Scissor Lift Certification Alberta

Scissor Lift Certification Alberta - Many worksites and tradespeople like for example welders, masons and iron workers make use of scissor lift platforms in order to help them reach elevated work areas. The use of a scissor lift is usually secondary to their trade. Thus, it is vital that all platform operators be well trained and licensed. Regulators, industry and lift manufacturers all work together to ensure that operators are trained in the safe utilization of work platforms.

Scissor lift work platforms are otherwise called manlifts or AWPs. These work machinery are quite simple to operate and offer a steady work surroundings, however they do have risks as they lift individuals The following are various key safety issues common to AWPs:

In order to protect individuals working around work platforms from accidental discharge of power due to close working proximities to wires and power lines, there is a minimum safe approach distance (likewise referred to as MSAD). Voltage can arc across the air and cause injury to employees on a work platform if MSAD is not observed.

Care must be taken when lowering a work platform to ensure stability. The boom should be retracted, if you move the load toward the turntable. This will help maintain stability if the -platform is lowered.

The regulations about tie offs do not mandate those working on a scissor lift to tie themselves off. Several groups will on the other hand, need their workers to tie off in their employer guidelines, job-specific risk assessments or local regulations. The anchorage provided by the manufacturer is the only safe anchorage to which harness and lanyard combinations should be attached.

It is essential to observe and not exceed the maximum slope rating. The grade could be measured by laying a board on the slope or by laying a straight edge. A carpenter's level can then be placed on the straight edge and raised until the end is level. By measuring the distance to the ground and dividing the rise by the length of the straight edge, then multiplying by 100, you can determine the percent slope.

A standard walk-around inspection should be carried out to determine if the unit is mechanically safe. A site assessment determines if the work place is safe. This is important particularly on changing construction locations due to the possibility of obstacles, contact with power lines and unimproved surfaces. A function test should be carried out. If the unit is operated correctly and safely and proper shutdown procedures are followed, the chances of incident are greatly lessened.

Click to Download the pdf